APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

EA4EUO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4EUO. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1732265273	-54 dbm	2.96 V
1732265213	-52 dbm	2.96 V
1732265154	-52 dbm	2.96 V
1732265093	-52 dbm	2.96 V
1732265033	-52 dbm	2.96 V
1732264973	-52 dbm	2.96 V
1732264913	-53 dbm	2.96 V
1732264854	-53 dbm	2.97 V
1732264793	-52 dbm	2.96 V
1732264733	-54 dbm	2.96 V
1732264673	-53 dbm	2.96 V
1732264613	-53 dbm	2.96 V
1732264553	-52 dbm	2.96 V
1732264493	-52 dbm	2.96 V
1732264433	-53 dbm	2.96 V
1732264373	-53 dbm	2.96 V
1732264313	-53 dbm	2.96 V
1732264253	-53 dbm	2.96 V
1732264193	-52 dbm	2.96 V
1732264133	-53 dbm	2.96 V
1732264073	-53 dbm	2.96 V
1732264013	-54 dbm	2.96 V
1732263953	-54 dbm	2.96 V
1732263893	-54 dbm	2.96 V
1732263833	-54 dbm	2.96 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)