APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

TA1BE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA1BE. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1732230063	-86 dBm	0.25 V
1732229333	-87 dBm	0.29 V
1732228603	-83 dBm	0.27 V
1732227873	-90 dBm	0.33 V
1732227143	-89 dBm	0.25 V
1732226413	-89 dBm	0.27 V
1732225683	-83 dBm	0.29 V
1732224953	-84 dBm	0.25 V
1732224223	-90 dBm	0.27 V
1732223493	-83 dBm	0.25 V
1732222763	-88 dBm	0.33 V
1732222033	-87 dBm	0.29 V
1732221303	-88 dBm	0.35 V
1732220573	-87 dBm	0.29 V
1732219843	-86 dBm	0.35 V
1732219113	-89 dBm	0.18 V
1732218383	-88 dBm	0.33 V
1732217653	-91 dBm	0.25 V
1732216923	-88 dBm	0.29 V
1732216193	-88 dBm	0.31 V
1732215463	-88 dBm	0.33 V
1732214733	-87 dBm	0.25 V
1732214003	-83 dBm	0.29 V
1732213273	-89 dBm	0.27 V
1732212543	-88 dBm	0.29 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)