APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

ED5YAS Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED5YAS. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732268473	121	143	51	143	38
1732268292	121	144	49	143	38
1732268112	121	144	47	143	45
1732267931	121	146	36	143	38
1732267750	121	147	83	143	38
1732267570	121	147	67	143	38
1732267389	120	141	92	143	38
1732267209	121	144	83	143	38
1732267028	120	141	70	143	38
1732266847	121	144	53	143	38
1732266667	120	140	55	143	38
1732266486	120	141	56	143	38
1732266306	120	139	53	143	38
1732266125	120	140	53	143	38
1732265944	120	141	45	143	38
1732265764	120	140	52	143	38
1732265583	120	140	69	143	38
1732265403	119	137	54	143	38
1732265222	120	139	69	143	38
1732265041	120	141	68	143	38
1732264861	120	142	71	143	38
1732264680	120	142	84	143	38
1732264500	120	142	44	143	38
1732264319	120	142	32	143	38
1732264139	119	143	78	143	38

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)