APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

IQ8PC-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IQ8PC-2. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732280066	190	16	2	72	74
1732280065	190	16	2	72	74
1732278265	190	19	4	77	74
1732276466	190	14	4	78	74
1732276465	190	14	4	78	74
1732274665	190	6	2	82	74
1732272866	190	7	2	78	74
1732272865	190	7	2	78	74
1732271065	190	12	4	80	74
1732269266	190	13	4	83	74
1732269265	190	13	4	83	74
1732267465	190	9	2	84	74
1732265666	190	6	1	75	74
1732265665	190	6	1	75	74
1732263865	190	7	2	79	74
1732262066	190	12	4	84	74
1732262065	190	12	4	84	74
1732260265	190	11	3	84	74
1732258466	190	7	2	81	74
1732258465	190	7	2	81	74
1732256665	190	6	2	82	74
1732254866	190	6	2	82	74
1732254865	190	6	2	82	74
1732253065	190	7	2	82	74
1732251266	190	7	2	81	74

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)