APRS.ro MAP

Reset

reset

F1ZZM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1ZZM-2. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Rx ed*	Dig ed*	Decode*
1737243711	92 Packet	12 Packet	70 %
1737240051	101 Packet	14 Packet	73 %
1737236392	95 Packet	12 Packet	69 %
1737232731	89 Packet	11 Packet	67 %
1737229072	86 Packet	14 Packet	74 %
1737225411	73 Packet	12 Packet	71 %
1737221751	33 Packet	5 Packet	67 %
1737218091	91 Packet	15 Packet	69 %
1737214432	79 Packet	12 Packet	72 %
1737210772	79 Packet	18 Packet	71 %
1737207112	92 Packet	14 Packet	76 %
1737203452	75 Packet	10 Packet	71 %
1737199792	81 Packet	18 Packet	72 %
1737196133	76 Packet	13 Packet	72 %
1737192472	77 Packet	18 Packet	69 %
1737188812	78 Packet	21 Packet	70 %
1737185152	60 Packet	9 Packet	67 %
1737181492	60 Packet	7 Packet	68 %
1737177832	61 Packet	10 Packet	68 %
1737174172	60 Packet	8 Packet	65 %
1737170512	58 Packet	7 Packet	65 %
1737166852	67 Packet	8 Packet	62 %
1737163192	75 Packet	8 Packet	70 %
1737159532	58 Packet	7 Packet	64 %
1737155872	65 Packet	11 Packet	64 %

*Used Equation Coefficients:

Vin: 0, 0.079, 0

Rx ed: 0, 1, 0

Dig ed: 0, 1, 0

Decode: 0, 1, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)