APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

ED1ZAJ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1ZAJ-3. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732241768	128	31	23	22	35
1732240869	128	30	22	22	36
1732239968	128	44	28	25	35
1732239069	128	40	26	24	36
1732238168	129	35	24	22	35
1732237267	128	33	23	22	35
1732236368	128	37	25	23	35
1732235468	128	34	24	22	35
1732234568	128	40	26	24	36
1732233667	128	41	27	24	35
1732232768	128	39	26	23	35
1732231868	129	35	24	22	35
1732230967	129	35	24	22	35
1732230068	128	40	27	24	35
1732229169	129	38	26	23	35
1732228268	128	41	27	24	36
1732227367	129	39	26	23	36
1732226468	130	34	24	22	35
1732225568	130	42	28	24	35
1732224669	130	39	26	23	36
1732223767	128	43	28	24	36
1732222867	129	41	27	24	35
1732221967	126	32	23	22	35
1732221067	128	39	26	23	35
1732220167	128	34	24	22	35

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)