APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

ED3YBA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED3YBA. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732284440	146	130	188	116	121
1732283531	147	129	178	115	121
1732282628	146	130	183	108	121
1732281721	141	132	149	106	122
1732280817	137	127	143	105	124
1732279911	137	127	144	105	126
1732279011	137	127	143	107	129
1732278104	137	126	143	109	132
1732277196	138	127	145	110	135
1732276264	138	126	144	112	137
1732275341	146	130	186	114	138
1732274385	144	130	186	116	138
1732273479	146	130	183	117	137
1732272552	145	130	183	116	134
1732271649	145	130	183	114	130
1732270733	144	130	183	111	127
1732269835	143	130	185	108	121
1732268924	141	131	185	106	116
1732268025	140	131	185	104	113
1732267111	139	131	185	103	110
1732266211	139	131	185	101	107
1732265302	138	131	186	98	104
1732264403	138	131	187	94	102
1732262590	144	156	154	88	98
1732261675	140	150	149	85	97

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)