APRS.ro MAP

Reset

reset

OK0BAF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0BAF-1. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1737226496	102	56	110	91	77
1737225595	91	51	108	91	77
1737224696	102	54	108	91	77
1737223795	92	46	108	91	77
1737222896	98	54	109	91	77
1737221096	102	56	108	91	77
1737220197	104	54	108	91	73
1737217496	104	55	108	91	67
1737216597	105	63	108	91	67
1737215697	106	54	108	91	73
1737214796	101	51	108	91	73
1737213895	111	58	109	91	77
1737212996	111	51	107	91	77
1737212097	98	55	108	91	77
1737210296	104	51	107	91	85
1737209397	108	51	108	90	85
1737208496	103	52	109	90	85
1737207597	114	53	108	90	73
1737206696	106	60	111	90	73
1737205796	109	53	108	90	73
1737204896	111	53	109	90	73
1737203997	113	59	108	90	73
1737203096	103	50	108	90	73
1737201297	92	51	110	90	74
1737200397	98	39	108	90	74

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)