APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

EA5AZW-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5AZW-9. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732292329	152	187	215	234	170
1732292274	152	195	218	224	158
1732292218	152	192	232	238	185
1732292163	152	181	214	233	176
1732292108	152	194	218	225	167
1732292053	152	195	218	219	172
1732291998	151	179	207	240	165
1732291942	151	183	219	237	176
1732291887	151	183	219	231	176
1732291832	151	193	218	218	166
1732291777	151	185	219	226	159
1732291721	151	193	214	232	176
1732291666	151	194	214	233	176
1732291611	151	195	222	242	166
1732291556	151	195	218	219	161
1732291501	150	198	221	230	167
1732291445	149	198	223	238	178
1732276693	153	193	221	234	179
1732276638	152	195	214	232	169
1732276583	152	192	229	236	172
1732276528	152	195	218	232	175
1732276472	152	196	218	218	170
1732276321	151	194	222	242	178
1732276142	152	193	221	234	181
1732276087	152	193	221	241	177

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)