APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

MB7VZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7VZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Mains*	Battery*
1732280476	14.11 V	13.71 V
1732276872	14.11 V	13.71 V
1732275071	14.11 V	13.71 V
1732273269	14.11 V	13.71 V
1732269665	14.11 V	13.71 V
1732267863	14.11 V	13.71 V
1732262459	14.11 V	13.71 V
1732257054	14.11 V	13.71 V
1732249847	14.11 V	13.71 V
1732244441	14.11 V	13.71 V
1732233631	14.11 V	13.71 V
1732230028	14.11 V	13.71 V
1732228226	14.11 V	13.71 V
1732226424	14.11 V	13.71 V
1732221018	14.11 V	13.71 V
1732219216	14.11 V	13.71 V
1732217414	14.11 V	13.71 V
1732215613	14.11 V	13.71 V
1732213811	14.11 V	13.71 V
1732212009	14.11 V	13.71 V
1732210208	14.11 V	13.71 V
1732208406	14.11 V	13.71 V
1732206604	14.11 V	13.71 V
1732203001	14.11 V	13.71 V
1732201199	14.11 V	13.71 V

*Used Equation Coefficients:

Mains: 0, 0.0993382, 0

Battery: 0, 0.0986131, 0

PktRcd: 0, 1, 0

Temp: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)