APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

YO8SBY-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO8SBY-13. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732133837	127	102	128	94	168
1732133776	128	99	129	122	168
1732133714	128	102	129	86	168
1732133652	127	102	129	89	168
1732133590	128	99	128	86	168
1732133528	128	99	128	86	168
1732133464	128	99	128	99	168
1732133402	128	102	129	76	168
1732133341	127	102	129	61	168
1732133279	127	102	128	109	168
1732133218	128	99	128	112	168
1732133156	128	99	128	117	168
1732133127	128	99	128	112	168
1732133065	128	102	128	73	168
1732133004	128	102	128	104	168
1732132942	128	99	128	119	168
1732132880	128	102	128	99	168
1732132818	128	99	128	99	168
1732132756	128	99	128	84	168
1732132694	128	99	128	102	168
1732132632	128	99	128	96	168
1732132571	128	99	128	112	168
1732132509	128	99	128	104	168
1732132448	128	99	128	119	168
1732132387	128	99	128	114	168

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)