APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

DH9SD-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DH9SD-9. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732207761	152	197	219	224	162
1732207702	152	197	219	238	177
1732207461	151	197	219	224	163
1732207401	151	198	220	218	171
1732206929	152	197	212	217	174
1732206869	152	202	224	229	172
1732205964	151	197	219	232	173
1732200517	151	199	218	235	171
1732200456	151	199	224	245	173
1732200274	147	197	220	240	181
1732199258	148	198	219	218	168
1732199136	147	197	220	240	181
1732199014	145	196	212	232	171
1732189898	147	200	220	238	174
1732189836	147	201	228	235	183
1732189778	146	202	228	228	172
1732189658	145	202	224	229	172
1732189598	144	200	216	236	177
1732188397	144	126	197	214	150
1732187207	145	198	223	237	178
1732187146	144	200	226	235	175
1732187092	143	155	210	217	152
1732184451	148	203	230	235	172
1732184388	148	201	221	240	181
1732184333	148	201	227	234	176

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)