APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

F1TKE-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1TKE-9. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732270605	131	44	255	175	139
1732270424	136	41	255	176	140
1732270243	140	39	255	177	141
1732270062	140	36	255	177	142
1732269688	139	28	255	180	146
1732269505	139	23	255	181	148
1732269143	140	15	255	184	151
1732268962	134	11	255	185	153
1732268780	111	8	255	186	152
1732215454	135	44	255	175	139
1732215273	135	40	255	176	140
1732215092	135	37	255	177	142
1732214730	135	30	255	179	145
1732214184	135	18	255	183	151
1732214002	110	15	255	185	151
1732184025	140	46	255	174	138
1732183659	139	41	255	175	140
1732183469	139	38	255	177	141
1732183286	140	35	255	178	143
1732182922	140	27	255	180	146
1732182737	140	24	255	181	147
1732182374	137	16	255	184	152
1732182194	112	15	255	185	150
1732127545	123	47	255	174	137
1732127364	135	46	255	175	138

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)