APRS.ro MAP

APRS.ro MAP About ☰ --:--:--

Reset

reset

TB4AEA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TB4AEA. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	Voltage*
1732308696	-80 dBm	0.06 V
1732307967	-82 dBm	0.06 V
1732307236	-79 dBm	0.06 V
1732306506	-80 dBm	0.06 V
1732305776	-81 dBm	0.06 V
1732305046	-80 dBm	0.06 V
1732304316	-82 dBm	0.06 V
1732303586	-86 dBm	0.06 V
1732302856	-84 dBm	0.06 V
1732302126	-86 dBm	0.06 V
1732301396	-83 dBm	0.06 V
1732300666	-81 dBm	0.06 V
1732299936	-82 dBm	0.06 V
1732299206	-81 dBm	0.06 V
1732298476	-85 dBm	0.06 V
1732297746	-83 dBm	0.06 V
1732297016	-82 dBm	0.06 V
1732296286	-84 dBm	0.06 V
1732295556	-85 dBm	0.06 V
1732294826	-84 dBm	0.06 V
1732294096	-85 dBm	0.06 V
1732293366	-84 dBm	0.06 V
1732292636	-79 dBm	0.06 V
1732291906	-84 dBm	0.06 V
1732291176	-81 dBm	0.06 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)