APRS.ro MAP

Reset

reset

SR9WXW Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9WXW. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Rx10min*	Vbatt*
1734601671	105 Pkt	13.12 V
1734601071	117 Pkt	13.16 V
1734601071	117 Pkt	13.16 V
1734599870	127 Pkt	13.16 V
1734599270	133 Pkt	13.1 V
1734598670	142 Pkt	13.06 V
1734598069	107 Pkt	12.98 V
1734597471	122 Pkt	12.98 V
1734597468	122 Pkt	12.98 V
1734596267	152 Pkt	12.64 V
1734596266	152 Pkt	12.64 V
1734595665	149 Pkt	12.5 V
1734595065	144 Pkt	12.44 V
1734595064	144 Pkt	12.44 V
1734594465	122 Pkt	12.44 V
1734594464	122 Pkt	12.44 V
1734593263	108 Pkt	12.08 V
1734592651	92 Pkt	12.04 V
1734592049	100 Pkt	12.02 V
1734592049	100 Pkt	12.02 V
1734591449	100 Pkt	11.94 V
1734591448	100 Pkt	11.94 V
1734590848	85 Pkt	11.9 V
1734590247	91 Pkt	11.86 V
1734589649	105 Pkt	11.88 V

*Used Equation Coefficients:

Rx10min: 0, 1, 0

Visc10min: 0, 1, 0

Digi10min: 0, 1, 0

Vbatt: 0, 0.02, 10

Tempre: 0, 0.5, -50

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)