APRS.ro MAP

Reset

reset

OR7F-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OR7F-9. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1737262619	14	1277	2668	53
1737262319	15	1277	2669	53
1737262019	15	1277	2671	53
1737261719	15	1277	2675	53
1737261419	14	1277	2678	53
1737261119	14	1277	2679	53
1737260819	14	1277	2682	53
1737260519	14	1278	2686	53
1737260219	14	1277	2689	53
1737259619	14	1277	2693	53
1737259319	15	1277	2696	53
1737259019	15	1277	2700	53
1737258419	15	1277	2707	53
1737258119	14	1279	2709	53
1737257819	14	1278	2714	53
1737257219	15	1278	2721	53
1737256919	15	1278	2723	53
1737256619	15	1278	2728	53
1737256019	15	1279	2736	53
1737255720	15	1279	2739	53
1737255419	15	1279	2743	53
1737255119	16	1279	2747	53
1737254819	16	1279	2751	53
1737254519	15	1278	2757	53
1737254219	15	1279	2761	53

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)