APRS.ro MAP

Reset

reset

ED1ZAJ-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1ZAJ-3. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1737275261	132	41	27	24	36
1737274361	131	40	27	24	35
1737273461	132	34	24	22	35
1737272562	131	35	25	23	36
1737271661	132	36	25	23	35
1737270761	132	37	25	23	34
1737269861	133	43	28	24	35
1737268961	131	37	25	23	35
1737268061	131	38	26	23	35
1737267161	132	39	27	24	35
1737266261	132	39	26	23	36
1737265361	132	37	25	23	35
1737264461	131	40	27	24	35
1737263561	132	33	24	22	34
1737262661	132	40	27	24	36
1737261761	132	37	26	23	35
1737260860	132	38	26	23	35
1737259961	132	28	22	21	36
1737259060	131	37	26	23	35
1737258160	131	38	26	24	35
1737256360	131	29	22	21	35
1737255460	132	38	26	23	35
1737254564	131	38	26	24	36
1737253660	132	35	25	23	36
1737252761	133	34	24	22	35

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)