APRS.ro MAP

Reset

reset

DG8AAC-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG8AAC-9. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1737260387	167	191	229	221	181
1737221400	159	211	224	225	169
1737221375	159	211	223	228	167
1737221320	159	213	227	232	173
1737221196	159	213	225	217	175
1737221070	159	213	227	232	173
1737220839	159	211	223	227	176
1737220790	158	213	225	233	181
1737220721	158	212	217	219	179
1737220629	159	213	225	219	183
1737220553	159	213	225	233	184
1737220469	159	213	225	219	179
1737220445	159	213	225	233	181
1737220420	159	211	225	233	179
1737216574	160	215	227	219	177
1737216533	160	216	221	225	173
1737216462	161	215	227	233	181
1737215798	161	215	227	233	189
1737215778	161	216	221	239	187
1737215724	161	216	223	241	179
1737215331	161	217	229	219	177
1737215294	163	219	232	216	165
1737215255	163	217	229	233	181
1737215214	163	219	233	224	163
1737215092	163	221	235	241	181

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)