APRS.ro MAP

Reset

reset

DG1RUE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG1RUE. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Battery*	Rx1h*
1737241515	13.29 Volt	43 Pkt
1737241214	13.29 Volt	42 Pkt
1737240914	13.29 Volt	41 Pkt
1737240614	13.29 Volt	40 Pkt
1737240314	13.29 Volt	39 Pkt
1737240013	13.29 Volt	39 Pkt
1737239713	13.29 Volt	38 Pkt
1737239413	13.29 Volt	37 Pkt
1737239112	13.29 Volt	36 Pkt
1737238812	13.29 Volt	37 Pkt
1737238512	13.29 Volt	37 Pkt
1737238211	13.29 Volt	37 Pkt
1737237911	13.29 Volt	38 Pkt
1737237611	13.29 Volt	38 Pkt
1737237311	13.29 Volt	37 Pkt
1737237010	13.29 Volt	35 Pkt
1737236710	13.29 Volt	34 Pkt
1737236410	13.29 Volt	32 Pkt
1737236109	13.29 Volt	32 Pkt
1737235809	13.29 Volt	31 Pkt
1737235509	13.29 Volt	29 Pkt
1737235208	13.29 Volt	28 Pkt
1737234908	13.29 Volt	27 Pkt
1737234608	13.29 Volt	28 Pkt
1737234308	13.29 Volt	27 Pkt

*Used Equation Coefficients:

Battery: 0, 0.078158, 0

Rx1h: 0, 1, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)