APRS.ro MAP

Reset

reset

IQ8PC-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IQ8PC-2. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1737226888	189	5	1	81	85
1737225088	189	6	1	83	85
1737225088	189	6	1	83	85
1737223288	189	6	2	88	85
1737221488	189	12	4	86	85
1737221488	189	12	4	86	85
1737219688	186	17	6	81	85
1737217888	186	19	5	79	85
1737217888	186	19	5	79	85
1737216088	186	17	4	85	85
1737214288	189	8	2	93	85
1737214288	189	8	2	93	85
1737212488	189	7	2	85	85
1737210688	189	7	2	80	85
1737210688	189	7	2	80	85
1737208888	189	8	2	82	85
1737207088	189	7	2	83	85
1737207088	189	7	2	83	85
1737205288	189	6	2	83	85
1737203489	189	5	2	84	85
1737203488	189	5	2	84	85
1737201688	189	6	2	83	85
1737199888	189	6	1	79	85
1737199888	189	6	1	79	85
1737198088	189	7	1	86	85

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)