APRS.ro MAP

Reset

reset

EA1BVF-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA1BVF-3. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1737227381	110	3	80	180	128
1737226180	117	4	80	181	128
1737224979	113	4	80	181	128
1737223778	103	2	80	182	128
1737222577	91	1	80	182	129
1737221375	89	1	80	183	129
1737218973	100	2	80	189	131
1737217772	108	2	80	193	131
1737216571	115	2	80	197	132
1737215370	118	1	80	195	132
1737214168	111	2	80	197	132
1737212968	96	2	80	196	132
1737211766	92	1	80	199	133
1737210565	90	2	80	199	133
1737209364	94	1	80	199	133
1737208163	98	2	80	200	133
1737206962	99	1	80	200	134
1737205761	92	1	80	200	134
1737204559	95	2	80	199	134
1737203358	100	1	80	199	135
1737202157	106	1	80	199	135
1737200956	104	1	80	199	135
1737199755	99	2	80	198	135
1737198554	98	2	80	198	136
1737197353	93	2	80	205	141

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)