APRS.ro MAP

Reset

reset

ED1ZAE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1ZAE-3. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1737256975	41	16	74	175	146
1737256374	41	17	74	175	146
1737255175	42	17	74	174	146
1737255174	42	17	74	174	146
1737253974	44	17	74	175	146
1737253375	46	17	74	175	146
1737252774	47	17	74	175	146
1737251575	43	16	74	176	146
1737251574	43	16	74	176	146
1737250374	45	17	74	176	146
1737249775	43	16	74	176	147
1737249174	42	16	74	175	147
1737247975	47	18	74	175	147
1737247974	47	18	74	175	147
1737246774	47	18	74	175	147
1737246175	47	18	74	175	147
1737245574	46	18	74	175	147
1737244375	44	17	74	175	147
1737243174	45	17	74	175	147
1737242575	45	17	74	176	147
1737241975	47	19	74	175	147
1737240775	47	19	74	175	146
1737240775	47	19	74	175	146
1737239575	46	18	74	175	147
1737238975	47	20	74	175	147

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)