APRS.ro MAP

Reset

reset

ED5YAM Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED5YAM. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1737245464	496	567	999	47	499
1737245284	496	567	999	47	499
1737245103	496	567	999	19	499
1737244922	496	567	999	19	499
1737244742	496	567	999	21	499
1737244562	496	567	999	43	499
1737244382	496	567	999	28	499
1737244201	496	567	999	27	499
1737244021	496	567	999	32	499
1737243839	496	567	999	18	499
1737243658	496	567	999	28	499
1737243477	491	567	999	28	499
1737243297	496	567	999	11	499
1737243117	496	567	999	7	499
1737242936	493	567	136	4	499
1737242755	497	567	999	11	499
1737242574	497	567	999	4	499
1737242393	497	568	999	15	499
1737242212	497	568	999	15	499
1737242032	497	568	999	14	499
1737241852	497	568	999	40	499
1737241671	496	568	999	40	499
1737241490	496	568	999	47	499
1737241310	496	568	999	48	499
1737241130	497	568	999	47	499

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)