APRS.ro MAP

Reset

reset

ED1YBD-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1YBD-3. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1738300964	46	18	77	188	126
1738300063	43	16	77	188	126
1738299162	39	15	77	188	126
1738298261	37	14	77	188	126
1738297360	31	11	77	188	126
1738296459	29	11	77	188	126
1738295558	29	11	77	188	126
1738294658	29	11	77	188	126
1738293757	30	11	77	188	126
1738292856	32	12	77	188	126
1738291955	32	12	77	188	126
1738291054	33	13	77	188	126
1738290153	34	14	77	188	127
1738289253	34	13	77	188	126
1738288352	35	14	77	188	127
1738287451	36	14	77	188	127
1738286550	36	14	77	188	127
1738285649	36	15	77	188	127
1738284748	37	15	77	188	127
1738283847	37	15	77	188	127
1738282947	37	15	77	183	127
1738282046	35	14	77	188	127
1738281145	35	15	77	187	127
1738280244	28	12	77	188	127
1738279344	22	10	77	184	127

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)