APRS.ro MAP

Reset

reset

F5ZHS-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZHS-4. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1737267041	13.27 Volt	0 C
1737264939	13.27 Volt	0 C
1737262837	13.27 Volt	0 C
1737260736	13.27 Volt	0 C
1737258634	13.27 Volt	0 C
1737256532	13.27 Volt	0 C
1737254430	13.27 Volt	0 C
1737252328	13.27 Volt	0 C
1737250226	13.27 Volt	0 C
1737248124	13.27 Volt	0 C
1737246022	13.27 Volt	0 C
1737243920	13.27 Volt	0 C
1737241818	13.27 Volt	0 C
1737239716	13.27 Volt	0 C
1737237614	13.27 Volt	0 C
1737235512	13.27 Volt	0 C
1737233410	13.27 Volt	0.5 C
1737231308	13.27 Volt	0.5 C
1737229206	13.27 Volt	0.5 C
1737227104	13.27 Volt	0.5 C
1737225003	13.27 Volt	0.5 C
1737222901	13.27 Volt	0.5 C
1737220799	13.27 Volt	1 C
1737218697	13.27 Volt	1 C
1737216595	13.27 Volt	1 C

*Used Equation Coefficients:

Vin: 0, 0.079, 0

Temp: 0, 0.5, -64

A3: 0, 0, 0

A4: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)