APRS.ro MAP

Reset

reset

MB7VA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7VA. If no packets are shown the sender has not sent any telemetry packets the latest 2 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1737245430	221	218	101	54	55
1737244806	221	218	101	54	51
1737244201	221	217	101	54	57
1737243606	221	217	100	53	55
1737243002	221	218	101	54	55
1737242402	221	217	101	54	55
1737241834	221	218	101	54	55
1737239409	221	217	100	54	55
1737237601	221	218	101	54	55
1737236998	221	217	100	53	55
1737235801	221	217	101	54	55
1737235198	221	217	101	54	55
1737234610	221	218	101	54	55
1737234011	221	218	101	54	55
1737232201	221	218	101	54	55
1737231610	221	217	101	54	55
1737230998	221	218	101	54	55
1737230403	221	217	101	54	55
1737229800	221	217	101	54	55
1737229203	221	218	101	54	55
1737228608	221	218	101	54	55
1737227997	221	218	101	54	55
1737227415	221	217	101	54	55
1737226809	221	218	101	54	55
1737226203	221	217	101	54	55

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)